This is the Hot Racing 46 Tooth Hardened Steel Mod 1 (1.0 metric pitch) Spur Gear
Features
CNC machined hardened steel construction - Black oxide finished - Laser etched tooth count marking
Specifications
Overall diameter: 48.7mm - Gear face width: 8mm
Replace TRA plastic 6447 or 6447X 54T spur gear
Includes
(1) 46 Tooth 1.0 Modulus Steel Spur Gear
Requirements
Do NOT use the pin system for setting the gear mesh. Instead, manually set the gear mesh without the pins. Refer to the TRA manual for instructions (ref. pg.22 - Adjusting Gear Mesh) - With the pins removed, use the four 4x16mm button-head cap screws on the bottom to set gear mesh. Loosen the four 4x16mm button-head cap screws. Cut a narrow strip of notebook paper and run it into the gear mesh. Slide the motor and pinion gear into the spur gear. Tighten the four 4x16mm button-head cap screws, and then remove the strip of paper. You should be able to run a fresh strip of paper through the gears without binding them.
Accessory Part For:
E-Revo 2.0
Maxx
X-Maxx 8S
XO-1
XRT 8S
